Hi everyone,
hope you are fine!
I am very new to BODS and do not understand how to use Table_comparison with a SAP BW Target DataStore - if this is possible at all?
We are on SAP BW 7.3 and BODS 4.1.
Source in this scenario is Oracle View.
I saw a lot tutorials how table_comparison works, but how this will be achieve when you have an Oracle view as a source and a SAP BW as a target.
What I did and works is.
- I have created a Job in BODS Designer populating the values from Oracle view to SAP BW
- I am only able to start the Job from SAP BW using an InfoPackage in Full mode, which I have created manually.
- if I start the job from BODS Designer I am receiving errors - maybe not sufficient rights.
But now I would like to implement a Delta. Therefore I am using the table_comparison.
So the steps would be then:
- Run the init job - so full into SAP BW
- adjust this job and implement the table_comparison
- create a template table based on the source
- as there is no option to choose the SAP BW target DataStore in the table_comparison
And what next?
Should I leave the SAP BW Target in the dataflow?
Or should it be replaced bye the template table (as target)?
And do I have to create another Job where the template Target is the Source populating into SAP BW target?
And do I have to adjust the InfoPackage on SAP BW side telling it, that you are now Delta?
Sorry if this is a bit confusing, but I would only understand how target_comparison works for SAP BW target?
Thanks very much in advance for your hints.
It is much appreciated.
bye Ömer